Hi,

Thanks for your reply.Now when I start with --ClusterBackend --CGateBase c:\CommuniGateFiles parameter it works fine.
But when I start with --ClusterBackend --CGateBase c:\CommuniGateFiles --SharedBase Y:\SharedDomains parameter it doesn't work. I am not able to access even the localhost:8010 page in this case.
I have created "SharedDomains" on Y:(Mapped Drive).So I have to use "Y:SharedDomains" as the sharedbase.

Thanks & Regards
Ranju

----- Original Message ----- From: "Technical Support" <support@stalker.com>
To: "CommuniGate Pro Discussions" <CGatePro@mail.stalker.com>
Sent: Saturday, September 06, 2008 2:04 PM
Subject: Re: Dynamic Clustering in Windows

Hello,

Ranju wrote:

Hi,
 I am configuring Communigate Pro Dynamic Clustering in windows.I started communigate from command prompt with the following command.
C:\WINDOWS\CommuniGatePro>CGServer.exe --ClusterBackend --CGateBase c:\CommuniGateFiles --SharedBase Y:\SharedDomains.It works fine.
But when I restart it from services it doesnt take any cluster configuration. I added the parameters in registry as given below.
Still it doesnt take the cluster configuration.
 "ImagePath REG_EXPAND_SZ C:\WINDOWS\CommuniGatePro\CGStarter.exe --ClusterBackend --CGateBase c:\CommuniGateFiles --SharedBase Y:\SharedDomains"
 I just wanted to know how I can add the cluster parameter(--ClusterBackend --CGateBase c:\CommuniGateFiles --SharedBase Y:\SharedDomains)
 in communigate pro service(which is displayed in services.msc window).

Please see <http://www.communigate.com/CommuniGatePro/SysAdmin.html#NTOptions>

In registry these parameters are stored as
HKLM\SOFTWARE\Stalker\CommuniGatePro\Parameters

Thanks & Regards
Ranju

-- Best regards,
Dmitry Akindinov

=======================================================================
When answering to letters sent to you by the tech.support staff, make
sure the original message you have received is included into your
reply.

#############################################################
This message is sent to you because you are subscribed to
 the mailing list <CGatePro@mail.stalker.com>.
To unsubscribe, E-mail to: <CGatePro-off@mail.stalker.com>
To switch to the DIGEST mode, E-mail to <CGatePro-digest@mail.stalker.com>
To switch to the INDEX mode, E-mail to <CGatePro-index@mail.stalker.com>
Send administrative queries to <CGatePro-request@mail.stalker.com>

#############################################################
This message is sent to you because you are subscribed to
 the mailing list <CGatePro@mail.stalker.com>.
To unsubscribe, E-mail to: <CGatePro-off@mail.stalker.com>
To switch to the DIGEST mode, E-mail to <CGatePro-digest@mail.stalker.com>
To switch to the INDEX mode, E-mail to <CGatePro-index@mail.stalker.com>
Send administrative queries to <CGatePro-request@mail.stalker.com>